Quatro® Dielectric Regular Boots
Arc Flash Testing
The Quatro Dielectric boots have been independently tested for arc flash protection using ASTM F2621 (IEC 61482-1-1 Method B).
After testing at 40cal/cm2, the Quatro Dielectric boots did not melt, drip, ignite or exhibit after-flame, during or after the exposure. Additionally, there was no sign of energy transfer inside the boot.
Yellow dielectric boots are being phased and replace with gray boots. Testing results still apply.
description
Key Features
- High-spec, fully waterproof, hand-built, rubber dielectric safety boot.
- Manufactured with specially formulated insulating layers offering electrical protection over the whole boot.
- Grey upper allows for easier visual identification and in-service inspection.
- Built on the popular Quatro last to give a generous fit while locking the ankle and preventing heel slip.
Standards
ASTM F2413-18
M/I/75/C/75
ASTM F1117
20kV
Electrical Testing
Every boot is tested after manufacture at 20kV for 3 minutes in water as per ASTM F1116. Each boot carries a unique and traceable serial number for PPE management and control.
Arc Flash Testing
The product has been tested for arc flash protection using ASTM F2621 and IEC 61482-1-1 Method B, resulting in no ignition, melting, or dripping at 40cal/cm2.
Buy Now from Anixter Buy Now from Saf-T-Gard Buy Now from Irby Utilities
An account or company name is required to order from Irby. Please call (800) 844-1811 or register if you do not have an account and wish to order.
DOWNLOAD PRODUCT DATA SHEET
Quatro® Dielectric Brochure
DOWNLOAD ARC FLASH TEST RESULTS
Related Products
-
Quatro Dielectric Thermal Boots
Insulated
-
Quatro Dielectric Overshoes
Slip On
-
Quatro Dielectric Overshoes
2 Buckle